Table of Contents
Advertisement
Connection to a Standard Definition TV or Monitor
Using the HD/SD COMPONENT OUT or VIEWFINDER COMPONENT OUT Terminal
1
• Refer to the connection diagram in the previous section (
• Select the appropriate component video signal depending on the TV or monitor you connect.
Open the menu and select [SIGNAL SETUP]. Select [COMP.OUT], select a setting
option and close the menu.
Using the A/V1 or VIDEO 2 Terminal
2
• Refer to the connection diagram in the previous section (
• If connecting to a TV set with a 4:3 aspect ratio, change the [LETTERBOX] setting appropriately.
Open the menu and select [SIGNAL SETUP]. Select [LETTERBOX], set it to [ON] and
close the menu.
3
Using the SCART Adapter
• If connecting to a TV set with a 4:3 aspect ratio, change the [LETTERBOX] setting appropriately.
Open the menu and select [SIGNAL SETUP]. Select [LETTERBOX], set it to [ON] and
close the menu.
We recommend powering the camcorder from a household power outlet.
TV sets equipped with the WSS System: Recordings made with a 16:9 aspect ratio (
be played automatically in widescreen mode whether you connect the camcorder to the TV using
the A/V1 terminal or VIDEO 2 terminal.
During fast forward playback, rewind playback and reverse playback of a tape recorded in HDV
standard, the picture may be distorted.
80
STV-290N Stereo Video Cable
(supplied)
Signal flow
78).
79).
SCART adapter
(commercially available)
Red
White
Yellow
32) will
Advertisement
Table of Contents
