Troubleshooting - Hoover U8341 Owner's Manual

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below.
What's the problem?
What's the cause?
Not firmly plugged in.
No voltage in wall plug.
What's the problem?
What's the cause?
Hard Surface mode selected on Surface Command™
control dial.
Agitator brush roll is obstructed.
What's the problem?
What's the cause?
Dirt cup full.
Pre-filter screen dirty.
Incorrect carpet height setting.
Blockage in system.
What's the problem?
What's the cause?
Incorrect carpet height setting.
What's the problem?
What's the cause?
Dirt cup full.
Pre-filter screen dirty.
Blockage in system.
What's the problem?
What's the cause?
Too much pressure being applied to tool.
Blockage in turbine channel.
Broken or worn belt.
Low cleaner suction.
18

Troubleshooting

Cleaner won't turn on.
Agitator brush roll brushes aren't turning.
Cleaner won't pick up.
Cleaner hard to push.
Cleaning tools won't pick up.
Powered pet hair cleaning tool agitator brush roll won't turn.
What's the solution?
Plug unit in firmly.
Replace fuse or reset circuit.
What's the solution?
Select a suitable carpet mode setting.
Disconnect cleaner from electrical outlet. Turn cleaner over and
remove any debris that has accumulated on the agitator brush
roll.
What's the solution?
Empty dirt cup.
Clean the pre-filter screen using the dusting brush tool.
Select another carpet height setting on the Surface Command™
control dial.
Clear blockage (see "Clearing blockages" section).
What's the solution?
Select a higher carpet height setting on the Surface Command™
control dial.
What's the solution?
Empty dirt cup.
Clean the pre-filter screen using the dusting brush tool.
Clear blockage (see "Clearing blockages" section).
What's the solution?
Continue using tool applying light pressure.
Remove blockage.
Replace belt.
Refer to items under "Cleaner won't pick up".