Table of Contents
Advertisement
AA68-03173A_00(E)-CHAPTER 3
O
Memorizing the Channels
Your TV can memorize and store all of the available channels for both "off-air" (antenna)
and cable channels. After the available channels are memorized, use the CH
CH
channels by entering the channel digits. There are three steps for memorizing channels:
selecting a broadcast source, memorizing the channels (automatic) and adding and
deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify
the type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press MENU to
display the menu.
Press the M button two
times to select "Channel",
then press the √ √ button.
2
Repeatedly press the
œ œ or √ √ button to cycle
through these choices:
ANT (antenna),
STD, HRC or IRC (all cable
TV).
Note: STD, HRC and IRC identify various types of cable TV systems. Contact your local cable com-
pany to identify the type of cable system that exists in your particular area.
At this point the signal source has been selected. Proceed to "Storing Channels in Memory" (next
page).
3
Press the MENU button twice to exit.
9/15/03
11:56 AM
P E R AT I O N
buttons to scan through the channels. This eliminates the need to change
Page 27
and
27
Advertisement
Table of Contents
