Connecting Your Dvd-Vcr - Samsung CHT-500 Instruction Manual

CONNECTING YOUR DVD-VCR

Connecting DVD-VCR to the TV using the
Coaxial Cable
1. Remove the aerial or network input cable from
the television.
2. Connect this cable to the 75 coaxial socket
marked on the rear of your DVD-VCR.
3. Plug the coaxial cable supplied into the
socket on your DVD-VCR.
4. Plug the other end of the coaxial cable into the
connector previously used for the aerial on the
television.
5. To obtain better pictures and sound quality on
your television, you can also connect your
DVD-VCR to the television via the SCART
cable (see section below) if your television is
equipped with this type of connection.
CAMCORDER
AM Antenna
DVD & VCR
AUX
AUDIO
IN OUT
R
RADIO ANT.
FM
75 L
COAXIAL
AM
VIDEO
AM Antenna
ANT.
Connecting DVD-VCR to the TV using the SCART Cable
You can connect your DVD-VCR to the television using the SCART cable if the appropri-
ate input is available on the television. You thus:
• Obtain better quality sound and pictures
• Simplify the setting up procedure of your DVD-VCR
• Regardless of the type of connection chosen, you must always connect the coaxial
cable supplied. Otherwise, no picture will be visible on the screen when the DVD-VCR
TV
is switched off.
• Make sure that both the television and the DVD-VCR are switched off before connect-
ing the cables.
1. Connect the coaxial cable as indicated in the above section.
2. Connect one end of the SCART cable to the AV1 (EURO AV) socket on the rear of the
DVD-VCR.
3. Plug the other end into the appropriate connector on the television.
COMPONENT VIDEO OUT
P B
COMPONENT VIDEO OUT
R L VIDEO
AUDIO
FRONT R FRONT L
P R Y
WOOFER
SPEAKERS
DVD Only
FRONT R FRONT L WOOFER
SURROUND R SURROUND L CENTER
S-VIDEO OUT
CENTER
SURROUND R SURROUND L
Connecting DVD-VCR to a Satellite Receiver or
Other Equipment
You can connect your DVD-VCR to a Satellite
receiver or other DVD-VCR using the SCART
cable if the appropriate outputs are available on
the equipment chosen. The following illustrations
give a few examples of the connection possibili-
ties.
1. AV1(EURO AV): By means of 21-pin Scart
Cable
Plug the SCART Cable with satellite receiver or
other equipment into the AV1 (EURO AV) sock-
et on the rear of the DVD-VCR.
After making this connection, select the source
by pressing the INPUT SEL. button for the AV1
input sources.
2. By means of RF Coaxial Cable
After making this connection, you must preset
the station received through the satellite tuner.
RF output channel of the satellite receiver
should be adjusted away from channel 36,
which is used by the DVD-VCR, e.g. re-adjust
to channel 39.
3. AV2 IN: By means of 21-pin Scart Cable
Plug the SCART Cable with satellite receiver or
other equipment into the AV2 (DEC./EXT.)
socket on the rear of the DVD-VCR.
After making this connection, select the source
by pressing the INPUT SEL. button for the AV2
input sources.
4. By means of RF Coaxial Cable
After making this connection, you must preset
the station received through the satellite tuner.
RF output channel of the satellite receiver
should be adjusted away from channel 36,
which is used by the DVD-VCR, e.g. re-adjust
to channel 39.
5