Day To Day Operation; Switch Your Receiver On/Off (Low Power, Standby); Select Tv Or Radio Service In Running Mode; Change Channels - Philips DTR2000/00 Manual

6

Day to day operation

6.1 Switch your receiver
ON/OFF (low power,
standby)
The rigth-hand led is lit in red
Your receiver is in "Low power" mode.
- Press the "LOW POWER" button on the
front of your receiver to restore the
previous mode, i.e. either standby or running
mode.This will take a few seconds.
Note:Your remote does not control the receiver
when it is in "Low power" mode.
The left-hand led is lit in orange
Your receiver is in standby mode.
To switch to running mode:
- Either press the following remote buttons:
"P+", "P-", "BACK", "TV/RADIO", or any
number button.
- Or press the "TV/RADIO" button on the
front panel.
To put your receiver in "Low power" mode
(<1W consumption):
- Press the "LOW POWER" button on the
front of your receiver.
The left-hand led is lit in green
You are in running mode.
To put your receiver in standby:
- Press the remote standby button.
To put your receiver in "Low power" mode
(<1W consumption):
- Press the front panel "LOW POWER"
button.
16 DAY TO DAY OPERATION
6.2 Select TV or Radio service
in running mode
To switch your receiver from TV to RADIO
and RADIO to TV:
- Press the remote control or the front panel
"TV/RADIO" button.
Note: The front panel and remote control
"TV/Radio" buttons have the same function.
6.3

Change channels

6.3.1

Using number buttons

While watching digital TV or listening to digital
radio:
- Dial a number using the remote number
buttons to select the corresponding channel.
- Press the "OK" button to confirm or just
wait for the selection to take effect.
6.3.2

Using "P+"/"P-" buttons

While watching digital TV or listening to digital
radio:
- Press "P+" to select the next channel in the
current channel list.
- Press "P-" to select the previous channel in
the current channel list.
Note: The "-" and "+" buttons on the front panel
have the same function as the "P-" and "P+"
buttons on the remote control.
6.3.3 Using the "BACK" button (last
channel recall)
While watching digital TV or listening to digital
radio:
- Press the "BACK" button to select the
previous TV/radio channel.