Advertisement
Numbers
correspond
Floor Damage
Slide dryer onto cardboard
or hardboard
More
movlng across floor.
Failure to do so may cause damage to
tloor coverlng.
to steps.
8.
6
H Now stand the washer/dryer
up. Slide
washer/dryer
onto cardboard
or hardboard.
To prevent
product
damage, do
not remove
corner
posts
betore
cutting.
n
With the corner
posts in place,
CI
the carton
down one corner.
Remove
carton.
12
n
Release washer
lid by pushing
up on latch.
Close lid.
out of washer.
Use new hoses and washers that came
with your washer/dryer.
H Read the yellow
zGd;ace
hand on top of
agitator
when removing
the
shipping straps. Firmly jerk,
then pull the three straps up
8
H Remove
the
two rear corner
posts
located
at the back
of the washer/dryer.
Remove
the two
until each
strap with key is
completely
removed
from
washer.
Put straps in the
same area as rear corner
shipping
pieces.
13
coupling
washer
n
Insert a flat washer
into
each
end
of the inlet hoses, Check
that washers are
firmly seated
in couplings.
corner
pieces
attached
to
the lower front of the washer/dryer.
Do
Not
remove
the foam shipping
pieces
between
the washer
and dryer until the unit is in place.
shippin
s
strap WI h
key
Inlet valves
are
plastic.
Do Not
strip or
crossthread.
14
Kl
I
Attach
hc
11
yellow card. Take
hoses out of
basket.
Place
hoses with other
parts,
9
H Move
foam shipping
pieces
outward
just enough
to clear the
washer lid. Open the washer
lid. The latch
under the dryer will hold lid open,
xe to bottom
-
-~
inlet valve
opening
first. Attach
second
hose
to top inlet valve.
Tighten couplings
by hand;
then use pliers to make an additional
two-
thirds turn.
IMPORTANT: THIS PROCEDURE MUST BE
FOLLOWED TO ASSURE PROPER
INSTALLATION.
cm
in)
15
H To prevent
the drain hose from
coming
off or leaking,
it must be installed
per
the following
instructions:
1. Wet the inside end of the drain hose with
tap water.
DO NOT USE ANY OTHER
LUBRICANT.
2. Squeeze
ears of small clamp
with pliers to
open clamp
and place
clamp
over end
of drain hose.
3. While holding
clamp
open,
work end of
drain hose onto drain connector
until
drain hose is within 0.64 cm (l/4 in) of
ribbed
stop.
4. Position clamp
over the drain hose area
marked
"clamp."
Release clamp.
Clamp
should be 0.64 cm (l/4 in) from end of
drain hose.
Panel C
Advertisement
