Installation Instructions Four-Wire Laundry System Washer•Dryer – 240 Volt IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use. Part No. 3405982...
Before you start... Important : Observe all governing WARNING codes and ordinances. Check location where washer/dryer will be installed. Proper installation is your responsibility. The washer/dryer must not be Check code requirements. Some codes limit installed or stored in an area where it will be or do not permit the installation of exposed to water and/or weather.
Exhaust requirements Now start... Maximum length of NUMBER With washer/dryer in laundry OF 90° 10.2 cm WARNING TURNS area. (4 in) dia. duct 6.4 cm 10.2 cm 10.2 cm WARNING (2-1/2 in) (4 in) (4 in) 13.1 m 12.5 m 11.0 m rigid Injury Hazard...
Page 4
Slide washer/dryer onto cardboard or hardboard before moving across floor to prevent damage to floor covering. Numbers correspond to steps. Place a piece of cardboard or hardboard in front of carton. Now stand the washer/dryer upright. Slide washer/dryer onto cardboard or hardboard.
Page 5
34. 35. 18. 24. Numbers correspond to steps. • Tilt the washer/dryer forward, raising back legs 2.5 cm (1 inch) off the floor so that the Standpipe or If you did not remove the rear self-leveling legs will adjust. Gently laundry tub drain system: access panel in lower the washer/dryer to the floor.
Recessed and closet Product dimensions installation (Shown with legs extended 1 inch from bottom of washer/dryer.) instructions 61 cm (24") 30.5 cm WARNING (12") Fire Hazard It is recommended that the washer/dryer be exhausted to the outside. If washer/dryer is installed in a closet, the Check that you dryer MUST be exhausted outside.