Advertisement
Before you start...
Check locatlon
where
washer/dryer
will be
installed.
Proper installation
is your
responsibility.
The washer/dryer
must not be
installed
or stored in an area where
it will be
exposed
to water and/or
weather.
Make
sure you have everything
necessary
for
correct
installation.
Location
should be large enough
to fully
open dryer door 90". (See Panel E for
'Recessed
and closet installation
instructions"
and "Product
dimensions,")
Check utllltles:
Proper electrical
supply
must
be available.
Dryer may be exhausted
from rear or left or right side.
Exhausting
through
the side
requires Side Exhaust Kit
LCK4600. See "Exhaust
requirements,
ti Panel B.
10.2 cm (4 In)
metal exhaust
duct Is required.
\
Standplpe draln system
needs a 5 cm (2 in)
diameter
standpipe
with a minimum
carry-
_
n
I-
I
Important : Observe all governing
codes and ordinances.
I
Electric Shock Hazard
Check code requirements.
Some codes limit
or do not permit the installation
of clothes
dryers in garages,
closets, mobile
homes and
sleeping
quarters.
Contact
your local
building
inspector.
Grounded electrlcal outlet
is required.
See
"Electrical
requirements,"
Panel A.
f
It Is the customer's responslblllty:
l
To contact a quallfled electrlcal
Installer.
. To assure that the electrlcal InstallatlOn
Is adequate
and In conformance
wlth
the Canadlan Electrlcal Codes, and all
local codes and ordinances.
Failure to do so could result In flre,
electrlcal shock or other personal InJury.
Hot and cold water faucets
must be within
1.2 meters (4 feet) of the back of the
washer/dryer
and provide
water pressure of
34 to 690 kPa (5-100 psi).
Water heater:
Set to deliver
60°C (140°F)
water to the washer.
65.6 litres (14.2 Imperiafi)
away
capaclry
or
gallons)
per minute.
Top of standpipe
beatleast71.1
cm
(28 in) high and no
higher than 121.9 cm
(48 in) from floor.
Floor drain system
requires a siphon
break,
Part No.
285320, available
from your authorized
parts distributor.
I \-
.- -..pport
washer/dryer
weight
wifi
water and clothes
of 170 kg (375 lb).
Laundry tub drain sysiem
needs a 75.5 litres
(16.6 Imperial
gallons)
laundry
tub. Top of
tub must be at least 71 .l cm (28 in) high
no higher than 121.9 cm (48 in) from
If a longer drain hose is
needed,
Drain Hose Part
No. 388423, and Hose
Connection
Kit Part No. 285442,
are available
from your
authorized
parts distributor.
Product Damage
Do Not store or operate washer/dryer
below 0°C (32°F) (some water may
remaln In washer). Proper operatlon of
dryer cycles requires temperatures above
7.2% (45°F). See Use & Care Guide for
"Wlnterlzlng" InformatIon.
Failure to do so may result In damage
from freezlng.
Personal Injury Hazard
More than one person Is required to Ilft.
tilt, or move thls washer/dryer
because of
Its weight and size.
Failure to follow these lnstructlons may
result In personal InJury.
Fire Hazard
l
Do Not use or store gasoline, palnt,
thlnners and other flammable materials
near washer/dryer.
Fumes from such
materials could result In flre or
explosion.
l
Never Install washer/dryer
up agalnst
draperies or curtains or on carpet. To
do so may result In a fire.
l
Keep any and all Items from klllng or
collecting
behlnd the washer/dryer.
Failure to do so may result In a fire.
l
Replace all access panels before
operatlng washer/dryer.
Failure to follow these lnstructlons may
result In a fire, exploslon or electrlcal
shock.
Tools and materials
needed for
installation:
0.64 cm (l/4
in)
socket wrench or nut
driver
Electrical
requirements
OBSERVE ALL GOVERNING
CODES AND
ORDINANCE
Electrlcal Shock Hazard
. Electrlcal ground Is required on thls
product.
l
Improper connectlon
of the equlpment-
groundlng conductor
can result In a rlsk
of electrlcal shock.
l
Check wlth a quallfled electrlclan
If you
are In doubt as to whether the
appliance
Is properly grounded. Do Not
modify the power supply cord plug. If It
will not flt the outlet, have a proper
outlet Installed by a quallfled
electrlclan.
l
Do Not use an extension cord wlth thls
appliance.
Such use may result In a fire,
electrlcal shock or other personal
InJury.
l
Do Not have a fuse In the neutral or
grounding clrcult. Thls could result In a
rlsk of electrlcal shock.
Failure to follow these lnstructlons could
result In serlous InJury or death.
1.
A four-wire,
single-phase,
120/240- volt, 60-
Hz, AC only electrical
supply is required
on
a separate
3(lampere
circuit,
fused on
both sides of the line. (Time-delay
fuse or
circuit breaker
is recommended.)
2. This washer/dryer
is equipped
with a four-
wire, 30-amp
rated flexible-type
power
supply cord. It must be plugged
into a
mating
30-amp
receptacle
(NEMA-type
14-30R). See Figure 1.
Use 30-amp receptacle
where local codes
permit flexible-type
supply cord (pigtall).
14-30R I-wire
receptacle
Figure 1
Panel A
Advertisement
