Switching To The Setup Menu Screen; Switching To The Av Setting Screen; Switching To The Speaker Setting Screen; Switching To The System Setting Screen - Kenwood VZ-7000N Instruction Manual

System Setup Function
Setup Menu Screen
A V S E T
V I D E O
S Y S T E M
C L O C K
S E T U P

Switching to the Setup Menu Screen

1
Press the FNC button on the monitor. The source
control screen is displayed (Page 13-22).
2
Touch [ MENU ] to switch to the setup menu
screen.

Switching to the AV Setting Screen

Touch [ AV SET ] to switch to the AV setting screen
(Page 8).

Switching to the Speaker Setting Screen

Touch [ SPEAKER ] to switch to the speaker setting
screen (Page 9).

Switching to the System Setting Screen

Touch [ SYSTEM ] to switch to the system setting
screen (Page 9).
Switching to the FM Transmitter Setting
Screen
Touch [ FM-TX ] to switch to the FM transmitter
setting screen (Page 10).
NOTE
When the Center unit is connected this function is not
displayed.

Switching to the TV Area Setting Screen

< VZ-7000P only >
Touch [ TV AREA ] to switch to the TV area setting
screen (Page 10).

Switching to the Video Setting Screen

< VZ-7000P only >
Touch [ VIDEO ] to switch to the video setting screen
(Page 11).

Switching to the Clock Adjustment Screen

Touch [ CLOCK ] to switch to the clock adjustment
screen (Page 11).
NOTE
When the Center unit is connected this function is not
displayed.
Switching to the Touch Panel Adjustment
Screen
Touch [ TOUCH ] to switch to the panel adjustment
screen (Page 12).

Canceling the Setup Menu Screen

Touch [ RTN ] to switch to the menu screen.
8
S P E A K E R
T O U C H
T V A R E A
F M - T X
RTN
AV Setting Screen
N A V
R G B A V I N
A V - I N
A V - O U T
N O R M T
V D 2 M O D E
A U T O V
A V S E T

Setting the Navigation Input

Touch [ RGB ], [ AVIN ] or [ OFF ] to switch the
Navigation input setting between the Video and the
Navigation modes according to a navigation
connected.
[7OFF] : Set the video mode
[7AVIN] : Set the navigation mode
[7RGB] : Set the navigation mode
NOTE
• If a navigation unit is connected to AV IN, be sure to
set it to [ AVIN ].
• If a navigation unit is connected to NAVI interface
terminal's, be sure to set it to [ RGB ].

Setting the AV Output

Touch [ NORM ], [ TV ] or [ VD ] to switch the AV OUT
terminal's output setting between normal, TV and
video mode.
[7NORM] : Same picture/sound as the picture on the
monitor
[7TV] : Picture/sound from television.
[7VD] : Picture/sound from AV IN terminal.

Setting the Video 2 Input

Touch [ AUTO ] , [ VD ] or [ OFF ] to switch the
VIDEO 2 IN terminal's input setting between auto,
video and off mode.
[7AUTO] : It becomes the Back View Camera mode
setting.
When the video signal input to the VIDEO
2 terminal, the monitor image is switched
to the image of the device connected to
the VIDEO 2 IN terminal.
[7V D] : It becomes the video mode setting.
Operate the V.SEL button when the
image from the device connected to
VIDEO 2 IN terminal is shown on the
monitor.
[7OFF] : It becomes the OFF mode setting.
Use this setting when there's nothing
connected to the VIDEO 2 IN terminal.

Ending the AV Setting Screen

Touch [ RTN ] to return to the setup menu screen.
O F F
V V D
D O F F
RTN
[NAV]
[AV-OUT]
[VD2-MODE]