Display Illumination Control; Dimmer; Contrast Adjustment; Display-Reversing Setting - Kenwood KDC-X9006U Instruction Manual

Display Illumination Control

This function turns off the display when you
perform no operation for 5 seconds. This function is
effective when you are driving at night.
Display Setting
"Display : ON" Keeps the display on.
"Display : OFF" Turns off the display when you perform no
operation for 5 seconds.
⁄
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 37) is set to OFF.
• When the display is off, pressing any key will turn on the
display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Ejecting the disc
• Turning off the power
• USB remove mode
• During function control, such as the Menu System, the
display stays on.
In Standby mode

Dimmer

Dimming this unit's display automatically when the
vehicle light switch is turned ON.
Display Setting
"Dimmer : ON" The display dims.
"Dimmer : OFF" The display does not dim.
In Standby mode

Contrast Adjustment

Adjusting the display contrast.
Display and Setting
"Contrast : 1"
"Contrast : 4" (Original setting)
In Standby mode

Display-reversing Setting

If no operation is performed for a predetermined
period of time, switching between negative and
positive display modes takes place automatically.
Display-reversing maintains the initial brightness of
the display for a long period of time.
Display
"Display N/P : Auto"
"Display N/P : POSI"
⁄
• Switching between negative and positive display may
not take place depending on the displayed mode.
In Standby mode

Built-in Amp Setting

Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP : ON" The built-in amplifier activates.
"AMP : OFF" The built-in amplifier deactivates.
Other than Standby mode/
When the Dual Zone System is ON

Dual Zone System Setting

Setting the Front channel and Rear channel sound
in the Dual Zone System.
Display Setting
"Zone 2 : Rear" Sub source (Auxiliary input source) is to be rear
channel.
"Zone 2 : Front" Sub source (Auxiliary input source) is to be front
channel.
Setting
Auto reverse display
Positive display only
|
English
33