Kenwood KDC-9023R Instruction Manual page 52

Installation
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
2
When the upper level is removed, remove the lower two
locations.
The frame can be removed from the bottom side in the same manner.
1
2
3
Lock
Catch
4
— 52 — — 52 —
Removing the Unit
Refer to the section <Removing the hard rubber frame> and
then remove the hard rubber frame.
Remove the screw (M4 8) on the back side.
Insert the two removal tools deeply into the slots on each
side, as shown.
Screw (M4X8)
(commercially
available)
Lower the removal tool
toward the bottom, and
pull out the unit halfway
while pressing towards the
inside.
Be careful to avoid injury from
the catch pins on the removal
tool.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
Accessory2
Removal tool