Table of Contents
Advertisement
Installation
■ Installing in Japanese-Made Cars
1
Refer to the section "Removing the hard rubber frame" (page 22)
and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory
screws.
N
T
N
T/N
T
T: Toyota cars
N: Nissan cars
• During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
■ Screwing the Faceplate on the Unit
If you want to fasten the
faceplate to the main unit so
that it does not fall off,
screw in the provided screw
(ø4 X 16 mm) in the hole
shown below.
Never insert the taptite screw (ø4 × 16 mm) in any other screw hole
than the one specified. If you screw it in another hole, it will contact
and may cause damage to the mechanical parts inside the unit.
8 mm
8mm
MAX.
MAX.
4
5
ø5mm
ø5mm
Accessory4...for Nissan car
Accessory5 ...for Toyota car
Accessory6
— 22 —
■ Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
2
When the lower level is removed, remove the upper two
locations.
The frame can be removed from the top side in the same manner.
Catch
Lock
Advertisement
Table of Contents
