Kenwood KAC-6402 Instruction Manual page 11

■ Tri-mode
CENTER UNIT
1
● Principle of Tri-mode
Method of frequency band division using a coil and capacitor...in case of 6dB/oct. slope
Crossover Frequency
0 dB
-3 dB
L
●
Example:
When it is required to set a crossover frequency of 120 Hz using speakers with an impedance of 4
ohms.
Prepare commercially-available coil and capacitor with the closest ratings to the results calculated from the
formula above. The capacitor rating should be as close as possible to 331.25 (µF) and the coil rating should
be as close as possible to 5.3 (mH).
CAUTION
2
• If you wish to bridge-connect a speaker, the speaker impedance must be no less than 4
ohms. Connecting a speaker with an impedance lower than 4 ohms may damage the unit.
• Be sure to connect capacitors to speakers to which high frequencies will be passed. Failure to do so will
result in a drop of the combined impedance with the subwoofer.
• Ensure that the withstand voltage and current ratings of the capacitors (C) and coils (L) are sufficient.
C
L L
(High pass)
A
R R
C
C
L L
B
R R
C
2 3
Coil (L): Passes low frequencies and blocks high frequencies.
Capacitor (C): Passes high frequencies and blocks low
C 159000
C=
fc x R
Frequency
159 x R
L=
fc
L
Subwoofer
(L + R) (Bridged)
L
(Low pass)
frequencies. (High pass)
(µF)
fc=Cut of Frequency (Hz)
R=Speaker Impedance (Ω)
(mH)
11
English