Programming Your Thermostat; Setting The Current Day And Time; Setting The Program Schedule And Heating Tempera Tures - Honeywell T8631A Owner's Manual

STEP 1
SETTING THE CURRENT
DAY AND TIME
You can program this thermostat
only on the wall with 24 Vac applied
to R and C terminals.
Always press the keys with your
fingertip or similar blunt tool. Sharp
instruments like a pen or pencil
point can damage the keyboard.
NOTE: Check the glossary, page
40, for definitions of unfamiliar
words.
STEP 2
SETTING THE PROGRAM
SCHEDULE AND HEATING
TEMPERATURES
Before You Begin...
The schedule form on page 43
provides an opportunity to plan your
schedule.
Now...
Start by programming the WAKE
time and temperature for weekdays.
The thermostat requires a program
for WAKE. You can program
LEAVE, RETURN and SLEEP or
not, as you please.

PROGRAMMING YOUR THERMOSTAT

SET
PRESENT
DAY/TIME
DAY
AHEAD
BACK
WAKE
SET
HEAT/COOL
DAY
AHEAD
BACK
Press and release. The display
shows 1:00 PM Mon.
Press and hold until the current day
appears in the display.
Press and hold until the current time
appears in the display. Be sure AM
or PM appears as desired.
You have programmed the current
day and time. Go on to Step 2.
Press and release. Note that the
display shows WAKE, the
preprogrammed time and tempera-
ture.
If the display reads COOL, press and
release to switch to HEAT.
If display reads SAT or SUN, press
and hold until MON TUE WED THU
FRI appears.
Press and hold until the display
shows the desired starting time. If
using T8631A in Conventional
Recovery ( visible in display). See
Glossary section. With Convential
Recovery the time should be set 30
or more minutes ahead of desired
comfort time to get the house
comfortable.
PM
MON
PM
TUE
PM
TUE
1
AM
SET
PT
MON TUE WED THU FRI ON HEAT
WAKE
AM
SET
PT
MON TUE WED THU FRI ON HEAT
WAKE
AM
SET
PT
MON TUE WED THU FRI ON HEAT
WAKE
AM
SET
PT
MON TUE WED THU FRI ON HEAT
WAKE
2