Check Thermostat Operation After
STEP 10
Programming And Installing
HEATING
Do not check heating system
operation by jumpering thermostat
terminals at the primary control
such as the gas valve, zone
valve,or oil burner control. This will
damage the thermostat. Instead,
you could jumper R and W wires at
the thermostat.
Cool
Off
Heat
Move the system switch to HEAT
and the fan switch to AUTO.
Auto
On
Temp
Press key until the setting is about
10° F [6° C] above room tempera-
ture. Heating should start and the
fan should run after a short delay
(immediately if fan operation switch
is set in E position).
Temp
Press key until setting is about
10° F [6° C] below room tempera-
ture. The heating equipment should
shut off.
25
INSTALLATION