Expansion-Card Connector; Removing The Expansion-Card Connector For 1U Node - Dell PowerEdge C6220 Hardware Owner's Manual

8 Replace the interposer extender. See "Removing the Interposer
Extender" on page 133.
9 Install the system-board assembly. See "Installing a System-Board
Assembly" on page 125.

Expansion-Card Connector

Removing the Expansion-Card Connector for 1U Node

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1
Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 124.
2 Remove the expansion card. See "Removing the Expansion Card for
1U Node" on page 136.
3 Remove the two screws securing the expansion-card connector to the
expansion-card bracket. See Figure 3-34.
4
Pull the expansion-card connector away from the expansion-card
bracket. See Figure 3-34.
Installing System Components | 163