Maytag MGR5755QDB - 30 Ing Gas Range Use & Care Manual page 6

LO: Use to simmer foods, keep foods
warm and melt chocolate or butter. Some
cooking may take place on the LO setting
if the pan is covered. It is possible to
reduce the heat by rotating the knob
toward OFF. Be sure flame is stable.
Hi: Use to bring liquid to a boil, or reach
pressure in a pressure cooker. Always
reduce setting to a lower heat when liquids
begin to boil or foods begin to cook.
An intermediate flame size is used to
continue cooking. Food will not cook any
faster when a higher flame setting is used
than needed to maintain a gentle boil.
Water boils at the same temperature
whether boiling gently or vigorously.
Surface Controls
- if flame should go out during a cooking operation, turn
Lhe burner off. If a strong gas odor is detected, open a
window and wait five minutes before relighting the
burnel
o Be sure all surface controls are set in the OFF position
before supplying gas to the range.
- NEVER touch cooktop until it has cooled, Expect some
parts of the cooktop, especiaii} around the burners, to
become warm or hot during cooking, Use potholders to
Pimot ess ignition
Pilotless ignition eliminates the
need for a constant standing
pilot light, Each surface burner
has a spark ignitor, Use care
when cleaning around the
surface burner.
If the surface burner does
not light, check if ignitor is
broken, soiled or wet.
BURNER CAP
Ports
gnitor
BURNER BASE
Surface Contro Knobs
Use to turn on the surface burners. An infinite choice of heat
settings usavailable from LO to Hm.At the Hm setting a detent
or notch may be felt. The knobs can be set on or between any
of the settings.
Graphics next to the knob identify which burner the O O
knob controls. For example, the graphic at right O O
shows the left front burner location.
Setting the controls:
The size and type of cookware wiii affect the heat setting. For
information on cookware and other factors affecting heat
settings, refer to "Cooking Made Simple" booklet.
1. Place a pan on the burner grate.
o The burner flame may lift off or appear separated from
the port if a pan is not placed on the grate.
2. Push in and turn the knob counterclockwise to the LiTF
setting.
o A clicking (spark} sound will be heard and tile burner
will light. {All four ignitors will spark when any surface
burner knob is turned to the LiTF position.}
3. After the burner lights, turn knob to desired flame size.
* The ignitor will continue to spark until the knob is
turned past the LiTE position.
Operating During a
Power Failure
When lighting the Surface burners, be sure all of the
hold it in position before turning the knob to MTE,
1. Hold a lighted match to the desired surface burner head.
2. Push in and turn the control knob slowly to LmTF.
3. Adjust the flame to the desired level.
5