Care of the machine
12.1.3
Electrostatic charger wire
If the electrostatic charger wire is dirty, streaks will appear though the printed images. If this occurs, follow
the procedure described below to clean the electrostatic charger wire.
1
Open the machine's front door.
2
Slowly pull out the charger-cleaning tool as far as
possible.
Next, slowly push in the charger-cleaning tool as far as
possible.
Repeat the above operations three times.
3
Securely insert the charger-cleaning tool, and then close the front door.
12.1.4
Print head
If the print head becomes dirty, decreased print quality may result. If this occurs, clean the print head
according to the following procedure.
1
Open the machine's front door.
2
Remove the print head glass cleaning tool from the front
door of the machine.
8650
12
12-3