Banner Printing Menu - Konica Minolta magicolor 8650DN User Manual

Settings for control panel
Note
To display the Admin. Settings Menu, the password is required.
Specify the administrator password in [Admin. Password] accessed by selecting [Admin. Settings] -
[Security Settings].
The factory default password is "1 2 3 4 5 6 7 8".
If an incorrect administrator password is entered, the Admin. Settings Menu does not appear.
When the password became invalid due to an administrator authentication failure and the machine
enters the restrict operation status, restart the machine.
[PrintDataCapture] is displayed when "OFF" is specified for [EnhancedSecurity].
[HDD Settings] and [User Box Settings] are displayed when a hard disk drive is installed.
[OverwritePriority] and [HDD EncryptionSet] are displayed when the Security kit is installed.
[EncryptionPassphrase] is displayed when [User-Defined] is specified for [EncryptionSetting].
[AuthDeviceSetting] is displayed when the authentication unit and HDD are installed.
[Finisher Adjust] is displayed when the finisher is installed.
[HDD Installation] is displayed when the hard disk drive is installed.
[Punch OptionSet] is displayed when the finisher is installed.
[Reading Timeout] is displayed when [Biometric] is specified for [Auth. Mode].

Banner Printing Menu

Note
When the Finisher FS-609 is installed, after setting Banner Printing to "ON", a message that prompts
you to remove the finisher from the machine appears.
When a print job is sent on the Banner Printing screen, printing is performed. When the job is sent, a
message prompting you to load paper appears. Load paper of the appropriate size.
To return to the original state, press the [Cancel] key on the Banner Printing screen, and then select
"Yes" for [OK to quit?] or "OFF" for the [Banner Printing] menu.
8650
8
8-15