Table of Contents
Advertisement
WARNING
Ground the machine with a correct ground source or you may be
electrically shocked.
1. The power source should be as follows:
100-240VAC, 50/60Hz, 3A or higher
2. Use a circuit with a dedicated breaker.
3. Install the machine as close to the wall outlet as possible.
4. If you want to move the machine, contact your service personnel.
1. Do not remove the screw and do not open the cover if not said to do so
in this User's Manual. If you ignore this warning, you may be burnt or
receive an electrical shock due to a hot part or electrically charged part
inside.
2. Do not disassemble or tamper with the machine.
It may result in a fire or an electrical shock.
1. Do not plug in the machine into a multi-wire connector in which some
other equipment is plugged into.
It may cause a fire due to outlet overheating.
2. Do not damage the power cord by stepping on or placing heavy objects
on it.
If the power cord is damaged, it may cause a fire or you may receive an
electrical shock. REPLACE THE CORD IF DAMAGED!
1. Do not put a flower vase, a flowerpot or any water-filled objects on the
machine.
Spilt water could cause a fire or an electrical shock.
2. If the machine generates an unusual smell or noise, turn it off and
unplug it from the wall electrical outlet immediately.
When disconnecting the power cord, be sure to hold its plug, or the
power cord is damaged and a fire or electric shock might be suffered.
(3)
Advertisement
Table of Contents
