Table of Contents
Advertisement
3. Pulling ST Tray Stopper (3), make a 90 degree turn in either direction to unlock
Stacker Unit (4).
4. Pull Upper Panel Assy (1) up again.
Keeping Upper Panel Assy (1) open with your hand, draw Stacker Unit (4) to the back side with
the other hand until it stops (about 200mm backward to stop).
This makes a space for jam removing operation around the printer.
1: open
NOTE
Lock Stacker Unit (4) with ST Tray Stopper after drawing it for safety.
5. Keeping Upper Panel Assy (1) open, pull the print (2) to the printer side to remove it from
inside Stacker Unit (4).
3: locked
4
6
3: unlocked
1: open
4
1: open
4
2
Advertisement
Table of Contents
