Mx-Pn11A/B/C/D (Punch Module); Unpacking; Installation - Sharp MX-2310U Installation Manual

[7] MX-PN11A/B/C/D (PUNCH MODULE)

MX-2310U
1.

Unpacking

A. Check the packed items
2
No. Name
1 Punch unit
2 Punch dust label
3 Punch position label (For the scanner)
4 Punch position label (For the RSPF)
2.

Installation

Before installation, be sure to turn both the operation and main
power switches off and disconnect the power plug from the power
outlet. Make double sure that the data lamp on the operation panel
does not light up or blink when performing installation.
Installation of the punch unit must be performed with the inner fin-
isher installed to the machine. If the punch unit is installed without
the inner finisher installed to the machine, when the inner finisher is
installed, the slide rail of the inner finisher may hit the punch unit
connector, damaging the connector.
1
3 4
Quantity
1
1
1
1
MX-2310U MX-PN11A/B/C/D (PUNCH MODULE) 7 – 1
Service Manual
A. Removal of the open/close cover and the path
guide
1) Remove the fulcrum cover.
2) Remove the clip. Remove the fulcrum, and remove the open/
close cover.
3) Remove the punch F cover.