Setting Up Scan To Computer - Lexmark CX410 User Manual

Scanning
5
Type a scan name.
Note: The scan name is the name that appears in the Scan Profile list on the display.
6
Click Submit.
Note: Clicking Submit automatically assigns a shortcut number. You can use this shortcut number when you are
ready to scan your documents.
7
Review the instructions on the Scan Profile screen.
a
Load an original document faceup, short edge first into the ADF tray or facedown on the scanner glass.
Notes:
• Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as
magazine clippings) into the ADF tray. Place these items on the scanner glass.
• The ADF indicator light comes on when the paper is loaded properly.
b
If you are loading a document into the ADF tray, then adjust the paper guides.
c
Do either of the following:
•
Press #, and then enter the shortcut number using the keypad.
Note: The scanner scans and sends the document to the directory you specified.
• From the home screen, navigate to:
Held Jobs > Profiles > locate your shortcut on the list.
8
View the file from the computer.
Note: The output file is saved in the location or launched in the program you specified.

Setting up Scan to Computer

Notes:
•
This feature is supported only in Windows Vista or later.
• Make sure that your computer and printer are connected to the same network.
1
Open the printers folder.
a
Click .
b
In the Start Search dialog, type Run.
c
In the Run dialog, type control printers.
d
Press Enter, or click OK.
2
Depending on your operating system, click Add a device or Add a printer.
3
Select your printer from the list.
Note: To identify your printer, print a network setup page, and then look for "Fully Qualified Domain Name" in
the TCP/IP section.
4
Click Next > Close.
5
From the printers folder, right‑click the printer, and then click Scan Properties or Properties to configure the scan
settings.
117