Usb; Sata Interfaces - Intel BLKDH61BEB3 Technical Product Specification

1.8

USB

The board supports up to ten USB 2.0 ports and two USB 3.0 ports.
The Intel H61 Express Chipset provides the USB controller for the 2.0 ports. The two
USB 3.0 ports are provided by the NEC UPD720200 controller. The port arrangement
is as follows:
• Two USB 3.0 ports are implemented with stacked back panel connectors (blue)
• Two USB 2.0 ports are implemented with stacked back panel connectors (black)
• Eight USB 2.0 front panel ports are implemented through four dual-port internal
headers
All 12 USB ports are high-speed, full-speed, and low-speed capable. The USB 3.0 ports
are super-speed capable.
NOTE
Computer systems that have an unshielded cable attached to a USB port may not
meet FCC Class B requirements, even if no device is attached to the cable. Use a
shielded cable that meets the requirements for full-speed devices.
For information about
The location of the USB connectors on the back panel
The location of the front panel USB headers
1.9

SATA Interfaces

The board provides six SATA connectors, which support one device per connector:
• Two internal SATA 6 Gb/s ports through the Marvell 88SE917X controller (blue)
• Four internal SATA 3 Gb/s ports (black)
The underlying SATA functionality is transparent to the operating system. The SATA
controller can operate in both legacy and native modes. In legacy mode, standard IDE
I/O and IRQ resources are assigned (IRQ 14 and 15). In Native mode, standard PCI
Conventional bus resource steering is used. Native mode is the preferred mode for
configurations using the Windows* XP, Windows Vista*, and Windows 7* operating
systems.
For more information, see: http://www.serialata.org/.
For information about
The location of the SATA connectors
Product Description
Refer to
Figure 9, page 42
Figure 10, page 43
Refer to
Figure 10, page 43
21