Assembling; Manual - Echo SRM-2305 Operator's Manual

Handle assembling bolt (8 mm)
Handle assembling
bracket (upper)
Handle assembling
bracket (lower)
Install handle assembling bracket (upper) in handle
assembling bracket (lower) and fix handle by tightening
handle assembling bolt (8 mm) lightly.
Adjust inclination of handle to adequate position (easy to
operate) and tighten firmly handle assembling bolt (8 mm).
1 - 2 mm
Nuts
Carburettor
CAUTION
After assembly, adjust the play of wire end on
carburettor side to 1 mm - 2 mm.
Bracket
Convex of fitting plate
Notch of
fitting plate
Fitting plate
INSTALLATION OF BRACKET
Fit bracket to mounting portion of angle transmission and
fix the bracket by holding fitting plate pressed from beneath
and tightening 4 bolts (M5 25) lightly.
Get notches and convexes of fitting plate to face
corresponding convexes and concaves of bracket, and fix
bracket tightening 4 bolts (M5 25) securely.
Washer
To engine

ASSEMBLING

Wire end
Bolt M5×25
13
Shaft tube
Throttle wire
To eliminate loosening of throttle wire fix it to shaft tube
(2 places) and to right hand U-handle (1 place) with wire
fixing clips.
Shield
There are two types of shields: namely one used exclusively
for Nylon line and another one used exclusively for steel
blade. When Nylon line is used, use the shield for Nylon
line. When steel blade is used, use the shield for steel
blade.
METHOD TO CHANGE SHIELD
(FOR STEEL BLADE)
Remove screw (M5 18) on the right side of the shield and
slide the shield to the left and remove it. Put shield of
another type into groove and slide it to the right until it stops
and be sure to fasten with the removed screw (M5 18).
When using Nylon line, use the shield for Nylon line
(see page 15). Fit cut off knife to the shield for Nylon line
using screw (5 12).
Wire fixing clip
Screw M5 18
Bracket
SRM-2305