Kyocera FS 8000C - Color Laser Printer Installation Manual

FS-8000C Series Printers
Installation Guide
Unpacking
1
Unpacking the Printer
Warning: To
avoid injury, the
printer must be
lifted and
carried by two
persons or
more.
Unpacking
the Paper Feeder
PF-30A for FS-8000C
PD-30 for FS-8000CD
The following setup assumes three paper feeders to be installed with the printer (including the one supplied as a standard accessory), which requires a CA-31B caster kit to
be installed on the bottom of the bottom paper feeder. If the extra paper feeders are not installed, the CA-31 casters may be used. See the Operation Guide for more details.
Placing the Printer
Attaching the Caster kit (purchased
3
separately): Remove each one screw to
remove four feet.
Using another topple-resistant bracket,
7
stack and joint the middle and top paper
feeder.
Installing the Fuser Unit, Oil Unit, Secondary Transfer Unit, and Waste Toner Bottle
11 Open the front cover.
Stand the paper feeder on its back side.
4
Install the caster kit onto the bottom of the
paper feeder.
Be sure to face
the longer end
towards the front
of the feeder.
8 Place the printer over the paper feeders (by
at least two persons).
12 Pull out thoroughly the paper feed unit.
Important!
Installation should be performed only by a qualified service personnel. Kyocera Mita
assumes no liability for any damage caused by an improper installation of the printer.
Checking Parts and Components
2
14
2
12
6
10
15
7
16
18
17
1 Documents
Installation Guide (This sheet)
Quick Reference Guide
CD-ROM
2 Cyan Developer
3 Magenta Developer
4 Yellow Developer
5 Black Developer
6 Cyan Toner Container
7 Magenta Toner Container
8 Yellow Toner Container
Place the paper feeder in a proper location.
5
Lock the stopper for each caster. Turn the
bolts to adjust height.
9 Join the printer and topmost paper feeder
with the jig provided by using one screw.
Unscrew the screw. Remove the lock pin
13
and release the (green-colored) lock lever.
Pull out the primary transfer unit until it
stops.
Screw
Lock Pin
Lock Lever
Continued on
the Reverse Page
8
9
3
5
13
9 Black Toner Container
10 Secondary Transfer Unit
11 Fuser Unit
12 Oil Unit
13 Waste Toner Bottles
14 Power Cord
15 Filter Duct
16 Quick Reference Guide Holder
17 Jig (Used in step 9)
18 Screws (Used in steps 9 and 16)
Using a topple-resistant bracket (supplied
6
with the CA-31B caster kit), stack and joint
the bottom and middle paper feeder.
10 Install the filter duct and the quick
reference guide holder. Peel the protective
tape off when attaching the holder.
Quick Reference
Guide Holder
Filter Duct
14 While pushing the gray lever, pull out
the primary transfer unit. Make sure
not to scratch the roller.
Gray Lever
1
4
11
13