Enabling And Disabling Ficon On The Switch; Setting Up A Basic Ficon Configuration - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 29 Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
When you enable the FICON feature in Cisco MDS switches, the following restrictions apply:
•
•
•
•

Enabling and Disabling FICON on the Switch

By default FICON is disabled in all switches in the Cisco MDS 9000 Family. You can enable FICON on
the switch either explicitly or implicitly by enabling FICON on a VSAN. However, disabling FICON on
all VSANs does not disable FICON on the switch. You must explicitly disable FICON.
To explicitly enable or disable FICON globally on the switch, following these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# feature ficon
Step 3
switch(config)# no feature ficon

Setting Up a Basic FICON Configuration

This section steps you through the procedure to set up FICON on a specified VSAN in a Cisco MDS
9000 Family switch.
Press Ctrl-C at any prompt to skip the remaining configuration options and proceed with what is
Note
configured until that point.
Tip If you do not wish to answer a previously configured question, or if you wish to skip answers to any
questions, press Enter. If a default answer is not available (for example, switch name), the switch uses
what was previously configured and skips to the next question.
To enable and set up FICON, follow these steps:
Issue the setup ficon command at the EXEC command mode.
Step 1
switch# setup ficon
OL-18084-01, Cisco MDS NX-OS Release 4.x
See the "Setting Up a Basic FICON Configuration" section on page
Manually addressing each prerequisite.
See the "About FICON" section on page
Use Device Manager (refer to the Cisco MDS 9000 Family Fabric Manager Configuration Guide).
You cannot disable in-order delivery for the FICON-enabled VSAN.
You cannot disable fabric binding or static domain ID configurations for the FICON-enabled VSAN.
The load balancing scheme is changed to Source ID (SID)—Destination ID (DID). You cannot
change it back to SID—DID—OXID.
The IPL configuration file is automatically created.
See the "About FICON Configuration Files" section on page
29-1.
29-33.
Purpose
Enters configuration mode.
Enables FICON globally on the switch.
Disables FICON globally on the switch and
removes all FICON configuration.
Cisco MDS 9000 Family CLI Configuration Guide
Configuring FICON
29-15.
29-15