Crossbar Modules - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Chapter 1 Product Overview

Crossbar Modules

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Crossbar Modules
The Cisco MDS 9513 Director supports two external crossbar modules located at the rear of the chassis.
Each Supervisor-2 module has an associated external crossbar module for redundancy. The Supervisor-2
module in slot 7 is associated with crossbar module 1 and Supervisor-2 in slot 8 is associated with
crossbar module 2. Redundant crossbar modules act in an active-active method, where each switching
module forwards traffic across both crossbar fabrics based on the intended destination. The traffic load
is shared across both crossbar modules. Each crossbar fabric channel connects to a fabric interface ASIC
on the switching modules through serial links on the midplane. Each Supervisor-2 processor also has a
20-Gbps (40-Gbps FDX) link to each crossbar fabric for participating in management and control
protocols and for in-band diagnostics.
The LEDs on the crossbar modules indicate the status of the crossbar modules. Table 1-6 provides more
information about these LEDs.
For information regarding migrating to Generation 3 modules, see the "Migrating to Generation 3
8-Gbps Fibre Channel Switching Modules" section on page A-1.
Figure 1-16 Crossbar Module LEDs
181335
Cisco MDS 9500 Series Hardware Installation Guide
1-25
OL-17467-02