Connecting To The Mgmt 10/100/1000 Ethernet Port - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Connecting to the MGMT 10/100/1000 Ethernet Port

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
If the default settings for the COM1 are modified, see the Cisco MDS 9000 Family CLI Configuration
Step 2
Guide containing information regarding verifying and resetting the default settings.
The default COM1 settings are as follows:
line Aux:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default: ATE0Q1&D2&C1S0=1\015
Statistics: tx:17 rx:0 Register Bits:RTS|DTR
Connecting to the MGMT 10/100/1000 Ethernet Port
To prevent an IP address conflict, do not connect the MGMT 10/100/1000 Ethernet port to the network
Caution
until the initial configuration is complete. For more information, see the Cisco MDS 9000 Family CLI
Configuration Guide.
The Supervisor-2 module supports an autosensing MGMT 10/100/1000 Ethernet port (labeled "MGMT
10/100/1000") and has an RJ-45 interface. (See
the switch by IP address, such as through Cisco Fabric Manager.
Figure B-3
Cisco MDS 9500 Series Hardware Installation Guide
B-6
Connecting to the MGMT 10/100/1000 Ethernet Port on the Supervisor-2 Module for
the Cisco MDS 9500 Series
M G M T
1 0 /1 0 0 /1 0
0 0
Chapter B Connecting the Cisco MDS 9500 Series
Figure B-3.) You can use this port to access and manage
OL-17467-02