Configuring Transparent Mode Static Mapping; Ip Iscsi Window-Setting Transparent Mode Static Mapping - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

• With the CLI:
Enter the show iSCSI initiator command.
Example:
MDS9216i# show iscsi initiator
iSCSI Node name is iqn.1991-05.com.microsoft:w2k3x03.sanbox.com
Initiator ip addr (s):
iSCSI alias name:
Node WWN is 21:0f:00:0d:ec:0d:2c:42 (dynamic)
Member of vsans:
Number of Virtual n_ports:
Virtual Port WWN is 21:0e:00:0d:ec:0d:2c:42 (dynamic)
Interface iSCSI 1/1, Portal group tag:
VSAN ID 1, FCID 0x7e0015
IMPORTANT:
By default, transparent mode mapping is set to
mode mapping must be set to
the HP Fibre Channel controller to the iSCSI Initiator.
Configuring transparent mode static mapping
The C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2), and
MDS 9216i switch have two modes of mapping IP addresses:
• Transparent mode dynamic mapping
• Transparent mode static mapping
You must enable static mapping for each iSCSI Initiator to guarantee persistent LUN mapping from the HP
Fibre Channel storage controller. There are two ways to enable static mapping:
• With the Device Manager GUI:
1.
Select IP > iSCSI from the Device Manager tool bar.
The IP iSCSI window appears
Figure 8 IP iSCSI window—Setting transparent mode static mapping
2.
Clear the Dynamic check box.
3. Select the Persistent check box.
4.
Select the System Assigned check box.
5.
Click Apply.
6. Close the IP iSCSI window.
33.33.33.143
1
1
Dynamic
Static
for each iSCSI Initiator to guarantee persistent LUN mapping from
(Figure 8).
0x0
when the initiator entry is created. Transparent
C-Series iSCSI 19