Presenting Eva Luns To The Iscsi Initiator; Host Folder-Add Host - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Presenting EVA LUNs to the iSCSI initiator

After the iSCSI Initiator connects to the EVA controller, the EVA recognizes the iSCSI Initiator WWPN that
was mapped from the C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module
(14/2),, or MDS 9216i switch as if it were a Fibre Channel HBA. The EVA can use the iSCSI Initiator
WWPN to create a host entry and present LUNs to the host entry.
NOTE:
This section describes configuring LUNs on an EVA. For configuring LUNs on other storage products,
refer to the procedures described in the product documentation.
The EVA is managed and configured with Command View EVA.
To create an EVA host entry:
1.
Select the Storage Array icon and click the Hosts folder
Figure 14 Host Folder—Add host
2.
Click Add host.
The Add a Host window appears
(Figure
(Figure 15).
14).
C-Series iSCSI 25