Brake Adjustment; Maintenance Schedule; How To Order Repair Parts - Chamberlain T Owner's Manual

A solenoid brake is standard on 3/4 and 1 horsepower models, and is optional on 1/3 and 1/2 horsepower
models. The brake is adjusted at the factory and should not need additional adjustment for the the life of the
friction pad.
Replace friction pads when necessary. Refer to the
illustration for identification of components for the
solenoid type brake system.
Check at the intervals listed in the following chart.
ITEM
Drive Chain
Sprockets
Clutch
Belt
Fasteners
Manual Disconnect
Bearings & Shafts
Use SAE 30 Oil (Never use grease or silicone spray).
Repeat ALL procedures.
Do not lubricate motor. Motor bearings are rated for continuous operation.
Do not lubricate clutch or V-belt.
Inspect and service whenever a malfunction is observed or suspected.
CAUTION: BEFORE SERVICING, ALWAYS DISCONNECT OPERATOR FROM POWER SUPPLY.

HOW TO ORDER REPAIR PARTS

OUR LARGE SERVICE ORGANIZATION
SPANS AMERICA
INSTALLATION AND SERVICE INFORMATION
ARE AVAILABLE 6 DAYS A WEEK
CALL OUR TOLL FREE NUMBER - 1-800-528-2806
HOURS 7:00 TO 3:30 p.m. (Mountain Std. Time)
MONDAY Through SATURDAY

BRAKE ADJUSTMENT

MAINTENANCE SCHEDULE

PROCEDURE
Check for excessive slack.
Check & adjust as required.
Lubricate.*
Check set screw tightness
Check & adjust as required
Check condition & tension
Check & tighten as required
Check & Operate
Check for wear & lubricate
Solenoid Brake System
Solenoid
Release Lever
EVERY
3 MONTHS
WHEN ORDERING REPAIR PARTS
PLEASE SUPPLY THE FOLLOWING INFORMATION:
PART NUMBER DESCRIPTION MODEL NUMBER
ADDRESS ORDER TO:
THE CHAMBERLAIN GROUP, INC.
Electronic Parts & Service Dept.
2301 N. Forbes Blvd., Suite 104
11
Friction Pads
Plate Assembly
EVERY EVERY
6 MONTHS 12 MONTHS
Tucson, AZ 85745