Chamberlain MEGA SLIDE-X Owner's Manual page 24

INSTALLATION CHECK OFF LIST
This Slide Gate operator is installed for use in a Class _____ installation.
Each item on this installation check off list should be verified by the installer.
_____ Two warning signs securely installed on each side of gate panel (required).
_____ 1 or 2 safety photo beams installed, one across each side of gate opening (required).
_____ 1 or 2 stop photo beams installed on each side of fixed gate panel (required).
_____ Customer advised that gate in for vehicular traffic only (required).
_____ A separate pedestrian entry and/or exit is provided (required).
_____ Contact edges installed and functional at all hazard or pinch points.
_____ Safety guards installed covering all cantilever wheels (required).
_____ All controls located far out of reach of gate, fixed panel and operator (required).
_____ This class operator is approved for the application of the operator (1, 2, 3 or 4) (required).
_____ A sphere with a 2-1/4" diameter cannot be pushed through the gate or fixed panel.
_____ A safety screen/mesh is installed with a minimum height of 4' from ground.
_____ Controls intended to reset gate after obstructed installed in line of sight (required).
_____ Hard wired contact sensors located and wired to avoid any mechanical damage.
_____ Customer instructed and is clear on proper use of gate operator (required).
_____ Customer instructed on proper use of all control devices used with operator.
_____ Safety instructions were reviewed and left with customer (required).
_____ Installer offered a preventative service/maintenance contract.
_____ A photo of completed installation taken from front and back of gate and dated.
_____ Gate conforms to the recommended ASTM F 2200-02 requirements.
Customer's Signature
Installer's Signature
Customer and installer should retain a copy of this check off list for their records.
01-60177D
© 2008, The Chamberlain Group, Inc.
All Rights Reserved
Date
Date