Table of Contents
Advertisement
MAXTOR ONETOUCH III MINI EDITION WINDOWS VISTA INSTALLATION
Installing the OneTouch III Mini Edition
Step 1 – Connect the Drive
1. Plug the Power + Data connector into an available USB port on
your system.
2. Plug the Power Only connector into an available USB port on
your system.
3. Connect the Type "B" connector to the OneTouch III Mini Edition Drive.
Note: If your computer does not supply enough power to the OneTouch
III Mini Edition through the red connector, plug in the unused black
connector on the 'Y' cable to another USB port on your computer (or a
powered USB hub).
If both ports fail to supply enough power to the drive, an optional power
supply should be purchased from Maxtor at www.maxstore.com
FIGURE 3 CONNECTING THE ONETOUCH III MINI EDITION
Small
Connector
Black
Red
Connector
Connector
PAGE 3
Step 2 – Install the Software
Important: Seagate suggests that you copy the software installation
program located on the OneTouch III Mini Edition to another location.
If you opt not to create a copy of this program or if your copy becomes
corrupt, you can download the program from Seagate's website at
www.seagate.com.
The installation software is located on the OneTouch III Mini Edition.
The following steps will guide you through the installation procedure.
1. After connecting the OneTouch III Mini to your computer, the AutoPlay
window opens. Click Run Launch.exe.
Note: In the event that the AutoPlay window does not open, click Start
Computer. Browse to and select the drive letter associated with the
OneTouch III Mini. Then double-click Launch (this may appear as
Launch.exe ).
2. A User Account Control window for the DemoShield Multi-CD Launch
needs permission to continue. Click Continue.
Advertisement
Table of Contents
