Negotiation; Flowcontrol - Dell PowerConnect 5324 Command Line Interface Reference Manual

• Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps.
Example
The following example configures the duplex operation of Ethernet g5 to force full duplex
operation.
Console(config)# interface ethernet g5
Console(config-if)# duplex full

negotiation

The negotiation Interface Configuration mode command enables auto-negotiation operation for
the speed and duplex parameters of a given interface. To disable negotiation, use the no form of
this command.
Syntax
negotiation
no negotiation
Default Configuration
auto-negotiation
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
• Turning off auto-negotiation on an aggregate link may, under some circumstances, make it
non-operational. If the other side has auto-negotiation turned on, it may re-synchronize all
members of the aggregated link to half-duplex operation, and may, as per the standards, set
them all inactive.
Example
The following example enables autonegotiation on Ethernet g5.
Console(config)# interface ethernet g5
Console(config-if)# negotiation

flowcontrol

The flowcontrol Interface Configuration mode command configures the Flow Control on a given
interface. To restore the default, use the no form of this command.
Ethernet Configuration Commands
123