Non-Skid Pads; Making Amplifier Settings; Connecting Your System - Pioneer S-RS55TB Operating Instructions Manual

Surround Speakers
For best results the speakers should be positioned at or above ear
level. Depending upon your room layout and preferences, the left
and right rear speakers should be positioned on the side walls just
the rear of the listening position, or on the walls.

NON-SKID PADS

Use the supplied non-skip pads as necessary according to the
location chosen for installation. Stick the non-skid pads on the four
corners of the surface of the speaker on which it will be installed.
There will be locations, however, where there will be little benefit
from using the non-skid pads, so avoid putting in slippery places.
Put the units on a soft cloth when performing this task.
1 2
1. Front Speakers
2. Surround Speakers
3. Center Speaker

MAKING AMPLIFIER SETTINGS

Before connecting the speakers, please read the operating
instructions supplied with your amplifier to select the speaker
setting of amplifier:
• Front speakers: Large
• Center / surround speakers: Small

CONNECTING YOUR SYSTEM

• Make sure all equipment is turned off before making any
connections.
• You will not get the proper surround effects from the speakers if
you connect the poles (+ and –) incorrectly.
• These speaker terminals carry HAZARDOUS LIVE voltage.
To prevent the risk of electric shock when connecting or
disconnecting the speaker cables, disconnect the power cord
before touching any uninsulated parts.
Connect to the speaker terminals on the rear of the speakers
Connect the speaker cables to the speaker terminals on the rear of
the speakers. The poles of the input terminals are red for positive
(+) and black for negative (–). Match the colors of the speaker
terminals and speaker cables when connecting.
2 En
3
Front speakers:
After loosening the speaker terminals, push the wires into the
terminals, then tighten firmly.
Black 
Center and surround speakers:
While pushing the tabs of the speaker terminals, push the wires
into the terminals.
Black 
Connect to the speaker terminals on the rear of the amplifier
Connect the speaker cables to the speaker output terminals on the
rear of the amplifier. (For details, refer to the amplifier's instruction
manual.)
Amplifier
• After connecting the cord to the terminal, pull the cord gently
to make sure the end of the cord is firmly connected to the
terminal. Incomplete connection may result in the sound
jumping or noise being output.
• To prevent damage to the circuits, ensure that the + and – wires
of the speaker cables and the left and right wires do not touch
each other. Also take care that the bare wires do not touch the
rear panel of the amplifier.
Red 
Red 
Speakers