Solving Hard Drive Problems - HP dx7500 - Microtower PC Service & Reference Manual

Solving Hard Drive Problems

Table C-4 Solving Hard Drive Problems
Hard drive error occurs.
Cause
Hard disk has bad sectors or has failed.
Disk transaction problem.
Cause
Either the directory structure is bad or there is a problem with
a file.
Drive not found (identified).
Cause
Cable could be loose.
The system may not have automatically recognized a newly
installed device.
The device is attached to a SATA port that has been disabled
in Computer Setup.
Nonsystem disk/NTLDR missing message.
Cause
The system is trying to start from a diskette that is not bootable. Remove the diskette from the diskette drive.
Solution
1. In Microsoft Windows XP, right-click Start, click
Explore, and select a drive. Select File > Properties >
Tools. Under Error-checking, click Check Now.
In Microsoft Windows Vista, right-click Start, click
Explore, and right-click on a drive. Select
Properties then select the Tools tab. Under Error-
checking click Check Now.
2. Use a utility to locate and block usage of bad sectors. If
necessary, reformat the hard disk.
Solution
In Microsoft Windows XP, right-click Start, click Explore, and
select a drive. Select File > Properties > Tools. Under Error-
checking, click Check Now.
In Microsoft Windows Vista, right-click Start, click Explore,
and right-click on a drive. Select Properties then select the
Tools tab. Under Error-checking click Check Now.
Solution
Check cable connections.
See reconfiguration directions in the
Installation Problems on page 168
does not recognize the new device, check to see if the device
is listed within Computer Setup. If it is listed, the probable
cause is a driver problem. If it is not listed, the probable cause
is a hardware problem.
Run the Computer Setup utility and ensure SATA1
Controller is Enabled in the Advanced menu.
Solution
Solving Hard Drive Problems 157
Solving Hardware
section. If the system still