Figure 1. Installing The Intel ® Raid Controller Rs2Wg160 - Intel RS2WG160 Hardware User's Manual

4. Connect the provided cables into the adapter using the 4-port combined end. Make
sure the controller and cables are properly attached and plug the cable into
connector at the inside edge of the adapter.
Note: To prevent throughput problems:
8
Figure 1. Installing the Intel
Use the cables provided or use the shortest possible cable.
Do not use cables longer than one meter.
Decrease the maximum length by one foot if you are using a backplane.
Do not use cross-over cables.
Only connect to a SATA drive, SAS or SATA backplane, or an expander
device.
Route the cables carefully.
Check that the controller and cables are all properly attached.
®
RAID Controller RS2WG160
Intel® RAID Controller RS2WG160 Hardware User's Guide
AF003502