Figure 2. Installing The Intel ® Raid Controller Rs2Wc040 - Intel RS2WC040 Hardware User's Manual

5. For the four drives (ports 0 - 3), connect one 4-port combined end of an internal
cable to the right connector (see letter "A" in
the cables to SATA drives or to the ports on a SATA or SAS backplane (see letter
"C" in
To prevent throughput problems:
Intel® RAID Controller RS2WC040 Hardware User's Guide
Figure 2. Installing the Intel
Figure 3).
Use the cables provided or use the shortest possible cable.
Do not use cables longer than one meter.
Decrease the maximum length by one foot if you are using a backplane.
Do not use cross-over cables.
Only connect to a SATA drive, SAS or SATA backplane, or an expander
device.
Route the cables carefully.
Check that the controller and cables are all properly attached.
®
RAID Controller RS2WC040
Figure 3). Connect the other end of
9