Accessing The System Board Components And Drives - Lenovo 4163B2U User Manual

Accessing the system board components and drives

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to access the system board components and drives.
To access the system board components and drives, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover to access the system board components. See "Removing the computer
cover" on page 14.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 14.
4. Pivot the drive bay assembly upward to access all the internal drives, cables, and other components.
Figure 9. Pivoting the drive bay assembly upward
5. To lower the drive bay assembly, press the drive bay assembly clip
assembly downward as shown.
16
ThinkCentre User Guide
1 inward and pivot the drive bay