Advertisement
Available languages
Available languages
EN
2. Detailed parts guide
MANUAL BREAST PUMP
a)
Funnel cover/Stand
b)
Let-down Massage Cushion
c)
Pump cover
d)
Silicone diaphragm and stem*
e)
Handle
f)
Pump body
g)
White valve*
3. Cleaning and sterilization
Before you use your breast pump for the first time and every time before use:
Separate all parts, then wash in the top shelf of the dishwasher or in warm
soapy water and rinse. Do not use antibacterial or abrasive cleaners/detergents.
Sterilize in a Philips AVENT Steam Sterilizer (Electronic or Microwave), or by boiling
for 5 minutes. If using a Philips AVENT Steam Sterilizer, the pump will remain
sterile in the sterilizer for a minimum of 6 hours, provided the lid
is not removed. (Always use distilled water.)
4. Keeping your breast pump sterile
for travel
After sterilizing all parts, insert the white valve (g) and fit the
diaphragm with stem (d) onto the pump body (f). Clip the
cover (a) over the funnel and Let-down Massage Cushion (b)
and screw on the sealing base (l) in place of the AVENT Feeding
Bottle (h).
2
BOTTLE
h)
AVENT Feeding Bottle (4oz/125ml)
i)
Dome cap
j)
Extra Soft Nipple, Newborn Flow (0m+)
k)
Screw ring
l)
Sealing base
m)
Sealing disc
*spares included
5.
Using the Manual Breast Pump
with the AVENT VIA Storage System
Simply replace the AVENT Feeding Bottle with a VIA Cup
and Adaptor. To make the pump completely stable insert
the VIA Cup into the VIA Lid/Stand.
6. How to assemble the Manual
Breast Pump
Please refer to diagram 6 at the beginning of this leaflet. Separate all
parts and ensure pump has been cleaned and sterilized as in section 3:
1)
Wash your hands thoroughly. Click the white valve (g) into the pump body
(f) from underneath.
2)
Place the pump body (f) onto the AVENT Feeding Bottle (h).
3)
Twist gently clockwise until secure. DO NOT OVERTIGHTEN!
4)
Place the silicone diaphragm with stem (d) into the pump body (f).
Make sure it fits securely round the rim by pressing down with your
fingers to ensure a perfect seal. (This is easier if assembled while wet.)
5)
Place the forked end of the handle (e) under the silicone diaphragm and
stem (d) and push down gently on the handle until it clicks into place.
6)
Carefully insert the Let-down Massage Cushion (b) into the pump funnel
(f) making sure it is perfectly sealed all round the rim of the funnel.
(This is easier if assembled while wet.)
7)
Click the pump cover (c) onto the pump body (f). To make the pump
completely stable insert the bottle into the stand (a).
EN
3
Advertisement
Chapters
