Turning Your Projector Off - NEC DLP Cinema NC3200S User Manual

3. Projection of Images (Basic Operation)

3-7. Turning your projector off

1
Press the POWER button on the projector control panel for three seconds or longer.
The lamp is turned off, the POWER button blinks white, and the Rear STATUS indicator blinks orange (cooling state).
The fan will continue to rotate while cooling, and the amount of time remaining for cooling is displayed on the LCD
screen. The cooling-off time is 5 minutes.
When the cooling is finished, the POWER button lights white, and the Rear STATUS indicator lights orange (standby
state). KEY LOCK becomes automatically on if no control panel operation takes place in the standby state for 30
seconds by default. Buttons on the control panel do not function while KEY LOCK is on. (See page 28)
LAMP MENU
IMB
2
Wait till the projector enters standby state before turning off the main power switch of the projector.
The POWER button is turned off and the main power is turned off.
3
Turn the main power switch on the lamp power supply to off.
The fan will continue to rotate for a short amount of time (approximately 5 seconds) immediately after turning off the power.
OFF
4
Turn off the AC power to the projector head and to the lamp power.
• In the following instances, do not turn off the main power switch or disconnect the AC power. Doing so can
NOTE
damage the projector.
- While projecting images
- While the fan is running after the power is turned off (The cooling-off time is 5 minutes)
30
KEY
LOCK
ENTER
DOUSER
EXIT
1
2 5
3
6
4
7
8
LAMP
MENU
IMB LOCK KEY
ENTE
R
DOUSE R
EXIT