Asus Maximus IV Extreme User Manual page 63

2. Intel P67 Serial ATA 3.0 Gb/s connectors
®
(7-pin SATA3G_3–6 [gray])
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical
disc drives via Serial ATA 3.0 Gb/s signal cables.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5,
and 10 configuration with the Intel
onboard Intel
®
• These connectors are set to [IDE Mode] by default. If you intend to create a
Serial ATA RAID set using these connectors, set the SATA Mode item in the
BIOS to [RAID Mode]. Refer to section 3.5.4 SATA Configuration for details.
Before creating a RAID set, refer to section 4.4 RAID configurations or
•
the manual bundled in the motherboard support DVD.
• When using hot-plug and NCQ, set the SATA Mode in the BIOS to [AHCI
Mode]. Refer to section �.�.4 SATA Configuration for details.
• You must install Windows
Serial ATA hard disk drives. The Serial ATA RAID feature is available only if
you are using Windows
ASUS Maximus IV Extreme
P67 chipset.
®
XP SP2 or later versions.
®
Rapid Storage Technology through the
®
XP Service Pack 3 or later versions before using
2-31