Asko T784 Operating Instructions Manual page 25

Installation instructions
To connect the exhaust duct to the rear
outlet
To connect the exhaust duct to the rear outlet,
follow the steps below:.
1. Push the duct onto the stub pipe and secure it
with a clamp
2. With the duct attached, insert the stub pipe into
the hole. It should snap into place.
3. After you push the dryer into place, check for
kinks in the duct.
NOTE!
Excessive duct length and too many bends can
impede drying performance. We recommend
that you cut off any excess exhaust duct and run
the duct with as few bends as possible. Make
any necessary bends as gentle as possible.
NOTE!
Maximum duct length of 60 feet and 4 elbows
are allowed. Subtract 4 feet of duct for each 90°
elbow.
Connecting the exhaust duct to the Left
or Right Side Outlet
To connect the exhaust duct to the left or right
side outlet, follow the steps below:
1. Using a flathead screw-driver, turn the exhaust
outlet cover you plan to use to the right or left
to align the tabs holding the cover in place.
2. Remove the exhaust outlet cover.
3. Remove the stub pipe from the rear exhaust
outlet and place it in the outlet you plan to use.
4. Push the duct onto the stub pipe and secure it
with a clamp.
5. With the duct attached, insert the stub pipe into
the hole. It should snap into place.
6. After you push the dryer into place, check for
kinks in the duct.
7. Use the exhaust outlet cover you removed from
the to cover the rear exhaust outlet.
WARNING!
To reduce the risk of fire, this appliance must be
exhausted OUTDOORS or the equivalent. Never
cover the end of the dryer stub or exhaust duct
with anything to catch lint, except for UL
approved vent basket.
Customer Care Center
1-800-898-1879
www.askousa.com
25