Optical Drive - HP 320 - Notebook PC Maintenance And Service Manual

CAUTION:
module authorized for use in the computer by the governmental agency that regulates wireless devices
in your country or region. If you replace the module and then receive a warning message, remove the
module to restore computer functionality, and then contact technical support through Help and Support.
Before removing the WLAN module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service door (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
white WLAN antenna cable is connected to the WLAN module "Aux" terminal.
2. Remove the two Phillips PM2.0×2.5 screws (2) that secure the WLAN module to the computer.
(The edge of the module opposite the slot rises away from the computer.)
3. Remove the WLAN module (3) by pulling the module away from the slot at an angle.
Reverse this procedure to install the WLAN module.

Optical drive

NOTE: All optical drive spare part kits include an optical drive bezel.
62 Chapter 4 Removal and replacement procedures
To prevent an unresponsive system, replace the wireless module only with a wireless
Battery on page
Service door on page
The black WLAN antenna cable is connected to the WLAN module "Main" terminal. The
53).
53).