Installing The Rear Mounting Brackets; Installing The Rear Mounting Brackets - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Sliding Shelf Installation for HAFM Server

Installing the Rear Mounting Brackets

Use the following procedure to install the rear mounting brackets for the HAFM
server shelf:
1. Select a U slot above the switch.
Note:
However, other U slots above the switch may also be used.
2. On each rack rear column, locate the hole that is 2 holes up from the EIA
3. Line up this hole with the threaded hole on the rear mounting bracket's side.
4. Using a screw, attach the bracket to the rack, as shown in
Note:
or 11000 series rack (square holes). If installing the bracket in a system/e rack (round
holes), the square alignment washer is not required.
5. Attach another screw loosely in the hole on the inside face of the rear
Figure 36: Installing the rear mounting brackets
78
HP recommends that you select the U slot immediately above the switch.
number of the selected U slot.
Figure 36 depicts the rear mounting bracket installation in an HP 9000, 10000
mounting bracket.
HAFM Server for Windows 2000 Installation Guide
Figure 36.