Monitoring Private Vlans - Cisco 3020 - Catalyst Blade Switch Release Note

Documentation Updates

Monitoring Private VLANs

Table 5
Table 5
Command
show interfaces status
show vlan private-vlan
[type]
show interface switchport
show interface
private-vlan mapping
This is an example of the output from the show vlan private-vlan command:
Switch(config)# show vlan private-vlan
Primary Secondary Type
------- --------- ----------------- ------------------------------------------
10
10
10
Updates to Command Reference Guide
This section contains these updates to the command reference:
•
•
•
•
•
•
•
•
•
Information Updates
These are information updates to the command reference:
•
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(40)SE1 and Later
36
shows the privileged EXEC commands for monitoring private-VLAN activity.
Private VLAN Monitoring Commands
501 isolated
502 community
503 non-operational
"Information Updates" section on page 36
"location (global configuration)" section on page 38
"location (interface configuration)" section on page 39
"private-vlan" section on page 40
"private-vlan mapping" section on page 42
"show location" section on page 44
"set and unset Bootloader Commands" section on page 46
"switchport mode private-vlan" section on page 46
"switchport private-vlan" section on page 48
The usage guidelines for the set and unset bootloader commands in the command reference are
incorrect.
These are the correct usage guidelines for the set command:
Environment variables are case sensitive and must be entered as documented.
Purpose
Displays the status of interfaces, including the VLANs to which they
belongs.
Display the private-VLAN information for the switch.
Display private-VLAN configuration on interfaces.
Display information about the private-VLAN mapping for VLAN SVIs.
Ports
Gi2/0/1, Gi3/0/2, Gi3/0/3
Gi2/0/1, Gi3/0/2, Gi3/0/4
OL-14130-02