T r o u b l e S h o o t i n g G u i d e ( c o n t . )
Low water flow
Probable Cause #1
Action
Probable Cause #2
Action
Probable Cause #3
Action
Spa is leaking
Probable Cause #1
Action
Motor does not run
Probable Cause #1
Action
Probable Cause #2
Action
Probable Cause #3
Action
Motor runs hot
Probable Cause #1
Action
Probable Cause #2
Action
Note: These motors will feel hot to the touch. This is normal. The
Overheat sensor will turn the motor off if there is an overload or
high temperature problem.
Dirty Filter
Remove filter cartridge and clean.
Closed gate valves or blocked lines.
Open all gate valves.
Low voltage or incorrect voltage
Have a Licensed Electrician check the line voltage
Loose connection.
Hand tighten all disconnects and fittings.
Check joints and unions
No power to motor.
Check power switches and circuit breakers. Check
motor plug where plugged into control panel.
Pump jammed from foreign matter in impeller.
Call dealer for recommended action.
Motor overheats during hot days while filtering.
Re-program your controls to cycle during the
coolest parts of the day and on shorter cycles.
(see programming instructions)
Pump ran dry.
Call dealer for recommended action.
Restricted suction lines
Make sure all valves are open/clear suction of debris.
30