D-2000 Control System; Preset Filter Cycles - Dynasty Spas D-1000 Owner's Manual

T o p S i d e C o n t r o l I n s t r u c t i o n s
D - 2000 System
Initial Start-up
When your spa is first powered up, it will automatically heat and
maintain 100 F until you change the set temperature.
Temperature Adjustment
Press the
is flashed on the display. In a few seconds, the numbers will
stop flashing, and the display will show the actual water temperature.
Pressing the pad a second time will cause the set temperature to increase
or decrease depending on what direction was last chosen. Each press will
change the set temperature in the same direction. If the opposite direction
is desired, release the pad and let the display revert to the actual water
temperature again. Press the pad to display the temperature, and
again to make the temperature change in the desired direction.
Jets
Press the
again for the high speed of pump 1 (and pump 2 if installed). Press the jets
pad again to turn off the pump(s). The low-speed pump also runs when the
heater is on (not on circulation pump systems) and during filter cycles. If
automatically activated, the low-speed pump cannot be disabled from the
front panel; however, the high-speed pump(s) may be started. The low-
speed pump turns off after 2 hours, and the high-speed pump(s) turn
off after 20 minutes.
Blower (optional)
Press the
automatically turn itself off after 20 minutes.
Light
Press the
ically turn off after 1 hour.

Preset Filter Cycles

Your spa will automatically filter itself twice each day. The first filter cycle begins
pad to display the temperature setting. The set temperature
pad to activate the low speed of pump 1. Press the pad
pad to turn the blower on and off. The blower will
pad to turn the spa light on or off. The light will automat-
14