Dynasty Spas D-1000 Owner's Manual page 17

T o p S i d e C o n t r o l I n s t r u c t i o n s
Circulation Pump (optional)
When the water is at set temperature or below, the circulation pump (if
installed) runs 24 hours a day. However, it turns off a 2 F above set
temperature and comes back on for 1 hour every 3 hours until it reaches
set temperature again.
Blower (optional)
Press the
blower is on low speed. Press a third time to turn off. The blower will
automatically turn itself off after 20 minutes.
Light
Press the
ically turn off after 1 hour.
Fiber Optic Light (optional)
Press the LIGHT pad once for the light and the color wheel, again for the
light to pause on one color, and again to turn the light completely off.
The light will automatically turn itself off after 1 hour
Standard and Economy Mode
Press the
Economy mode only heats the water during filter cycles. Standard mode
maintains the desired temperature at all times. We suggest using the
standard mode.
Panel Lock
Press the
LOC
will show
functions will continue to operate. To unlock the panel, push
JETS 1 again
Preset Filter Cycles
Your spa will automatically filter itself twice each day. The first filter cycle
begins 1 minute after the spa is energized. The second filter cycle will begin
12 hours after the start of the first filter cycle. Filter duration is programm-
able at the topside panel for FILO, FIL1, FIL2, FIL3 FIL4 or filc - 24 hours.
The default filter setting is 2 hours. To program, press the WARM or COOL
pad then the
time duration. Press the MODE pad again to exit the programming sequence.
During filtration, the low-speed pump will run and the blower operates for 30
seconds at the start of the first filter cycle to clean out the air channel.
The heater will also run during filter cycles. An ozone generator (if installed)
will run 24 hours/day.
Auxiliary Panel (optional)
The jets and blower (if installed) can also be activated from an
auxiliary panel. The operation is the same as described for the main
panel.
pad once to turn the blower on high. Press a second time,
pad to turn the spa light on and off. The light will automat-
pad to switch between standard and economy mode.
pad then JETS 1. The panel will be locked, and the LED
alternately with the water temperature. All automatic
pad. Press the WARM or COOL pad to select the filter
17
then